Skip to content
Haul Math

Blog

Trucking rates per mile by equipment type: dry van, reefer, flatbed

Scott Wilder
By , Editor
Updated

Flatbed and reefer loads pay more per mile than dry van, but a higher rate only helps if it clears your own cost per mile. Here are the sourced numbers and the break-even math.

Flatbed and reefer loads pay more per mile than dry van. In September, ACT Research reported DAT U.S. spot rates excluding fuel of $2.16 per mile for dry van, $2.69 for reefer and $2.60 for flatbed. ACT sells freight rate analysis and forecasting, so read the page as market data from a company with a product to sell. We found no sourced rate for box trucks in our research, so we do not give one.

Quick version

  • Reefer and flatbed spot rates sit above dry van in all three rate sources we reviewed: ACT Research, Truck Dispatch Experts and Trucking42. All three sell something related. ACT Research sells freight rate analysis and forecasting. Truck Dispatch Experts sells dispatch services. Trucking42 sells a freight dispatch service for owner-operators, so read its figures with that in mind.
  • Check whether a quoted rate includes fuel. The same market can look 63 cents apart depending on that one line.
  • A higher rate per mile only helps if it clears your own cost per mile, deadhead included.
  • Use the national averages as a sanity check, not as your break-even rate.

Spot rates by equipment type

The table below shows two snapshots of DAT spot rates. The columns use different months and different fuel treatment, so compare down a column, not across.

EquipmentSeptember spot, excluding fuel (ACT Research)June 2026 spot, all-in (Truck Dispatch Experts)
Dry van$2.16 per mile$3.00 per mile
Reefer$2.69 per mile$3.39 per mile
Flatbed$2.60 per mile$3.69 per mile

Truck Dispatch Experts sells dispatch services that book loads and negotiate rates, so it has a stake in how rates are framed. Its page says the June figures are DAT national averages. ACT's page says the September change from August was down 3 cents for dry van, up 7 cents for reefer and down 10 cents for flatbed. Rates move every month, and they do not all move the same way.

How big is the flatbed premium?

It depends on the month and the source. Here is the arithmetic from each:

  • September, excluding fuel: $2.60 for flatbed minus $2.16 for dry van is $0.44 per mile.
  • June, all-in: $3.69 for flatbed minus $3.00 for dry van is $0.69 per mile.

Trucking42 gives older numbers from mid-2025: about $2.07 for dry van, $2.44 for reefer and $2.58 for flatbed. On those, $2.58 minus $2.07 is $0.51 per mile. The same page says earning $0.20 to $0.50 more per mile than a comparable dry van haul is common for flatbed. Trucking42 promotes its own dispatch service, so treat its framing with care.

Our view: a flatbed premium of roughly 40 to 70 cents per mile is a fair reading of these three sources. That is our judgment from the figures above, not a sourced rule.

Contract rates versus spot rates

Spot is not the whole picture. ACT reports that its aggregate of DAT dry van, reefer and flatbed contract rates, excluding fuel, averaged $2.52 per mile in September, up 18% year over year, per ACT Research. The same page says the aggregate spot rate stood 16 cents below that contract rate.

The gap can flip. Truck Dispatch Experts says dry van spot at $3.00 per mile all-in moved above the $2.89 contract average in June 2026. It calls that the first time spot topped contract since February 2022. If you have contract freight, compare it to spot on the same fuel basis before you chase a spot premium.

Where box trucks and heavy haul fit

Box truck rates are not in any source we reviewed. Do not borrow the dry van number for a box truck. Build your own break-even from your costs and ask the broker what the load pays on a total-mile basis.

Heavy haul is the other extreme. Trucking42 says some seasoned heavy-haul owner-operators report spot rates of $5.00 to $10.00 or more per mile for particularly challenging loads. That is a self-reported range from a dispatch company, not a market average. The same page notes that these jobs can take a week to plan and execute.

What a higher rate does to your break-even math

A rate only matters against your cost. ATRI's 2025 analysis, reported by FleetOwner, puts the average operational cost of trucking at $2.34 per mile, up 3.4%. Excluding fuel, it is $1.85 per mile. Fuel was $0.48 per mile. ATRI covers Class 8 trucking costs overall, not each trailer type, and driver pay is part of its figure.

Here is a rough comparison. It sets the September rates excluding fuel from ACT Research against ATRI's $1.85 excluding fuel from FleetOwner. The two come from different periods, so this is a rough guide, not a forecast.

EquipmentRate excluding fuel minus average cost excluding fuel (FleetOwner on ATRI)Gap per mile
Dry van$2.16 minus $1.85$2.16 minus $1.85 is $0.31
Reefer$2.69 minus $1.85$2.69 minus $1.85 is $0.84
Flatbed$2.60 minus $1.85$2.60 minus $1.85 is $0.75

Our view: a bigger gap on paper does not make a load better. Flatbed work may carry costs a dry van does not, such as tarps and securement gear, and these averages do not include them. Add your own costs to your own cost per mile before you trust the gap. The cost per mile calculator and the break-even rate calculator show the math with your numbers.

Deadhead eats the premium

A high rate on the loaded miles can shrink fast once you count empty miles. Truck Dispatch Experts gives this example: a $3,000 load over 1,000 loaded miles is $3.00 per mile. Add 150 miles of deadhead and the total is 1,150 miles. Then $3,000 divided by 1,150 is about $2.61 per mile.

The same Truck Dispatch Experts page adds a 6% dispatch fee to its example of a $3,000 load over 1,150 total miles. Six percent of $3,000 is $180, which leaves $3,000 minus $180, or $2,820. Then $2,820 divided by 1,150 is about $2.45 per mile. That company sells dispatch services, so treat its fee example as an illustration. Flatbed loads often sit in thinner lanes, so check your empty miles before you accept the higher rate. The deadhead miles calculator does this division for you.

Fuel changes the comparison

DAT's national average rates on its Trendlines page include fuel surcharges. DAT sells RateView, the rate data service behind those charts. Truck Dispatch Experts says the June dry van gap between all-in and linehaul was 63 cents per mile, which is $3.00 minus $2.37 of linehaul.

Diesel is also higher now. Haul Math's home page shows the EIA average at $6.352 per gallon for the week of Oct 26, 2026, up $0.076 from the prior week. Truck Dispatch Experts says a truck averaging 6.5 MPG burns about $0.81 of diesel per mile at $5.257 per gallon. At $6.352, the same truck burns $6.352 divided by 6.5, which is about $0.98 per mile. That is $0.98 minus $0.81, or $0.17 per mile more than at the earlier price. Use the fuel surcharge calculator to see what a surcharge covers on your load.

How to compare a load across equipment types

  1. Ask whether the quoted rate includes fuel. If it does not, find out the surcharge.
  2. Divide the total pay by loaded plus empty miles.
  3. Subtract any fees, such as dispatch.
  4. Compare the result to your own cost per mile, not a national average.
  5. Check the market. The load-to-truck ratio on DAT Trendlines is described as a real-time indicator of the balance between spot market demand and capacity.

Use the averages as a check, not a target

National averages tell you roughly where the market sits. They do not know your lane, your fuel economy, your deadhead or your insurance. Spot and contract rates also move month to month, as the September changes above show. Your break-even rate is the number that decides whether a load works for you.

If you have a load in front of you, put the real miles and pay in. Run your numbers in the free load profit calculator and see the math before you answer the broker.

Common questions

Which pays more per mile, flatbed or dry van?
Flatbed paid more in every source we reviewed. [ACT Research](https://www.actresearch.net/resources/data-tracking/freight-trucking-rates) shows September spot at $2.60 for flatbed against $2.16 for dry van, excluding fuel. That is a $0.44 gap, and it changes month to month.
Do these rates include fuel?
It depends on the source. The [ACT Research](https://www.actresearch.net/resources/data-tracking/freight-trucking-rates) figures exclude fuel, while the June figures from [Truck Dispatch Experts](https://truckdispatchexperts.com/tools/rate-per-mile/) are all-in. DAT's [Trendlines page](https://www.dat.com/trendlines) says its national average rates include fuel surcharges.
What is the rate per mile for a box truck?
None of the sources we reviewed gives a box truck rate, so we do not state one. Work from your own cost per mile and the total-mile pay on the load.
Is a higher rate per mile always better?
No. A higher rate can still lose money after deadhead, fees and fuel. [Truck Dispatch Experts](https://truckdispatchexperts.com/tools/rate-per-mile/) shows a $3.00 per mile load falling to about $2.61 per mile once 150 miles of deadhead are counted.
What does it cost to run a truck per mile on average?
[ATRI's 2025 figure, reported by FleetOwner](https://www.fleetowner.com/operations/article/55392569/atri-report-breaks-down-class-8-truck-operating-costs-by-region-and-expense-category), is $2.34 per mile on average, or $1.85 excluding fuel. Your own cost will differ, so calculate it from your numbers.

Run your own numbers

Free calculators for owner-operators: load profit, cost per mile, IFTA, per diem, and more. Every answer shows the math.