Skip to content
Haul Math

Blog

How Many Miles Per Week Should an Owner-Operator Run to Make Money?

Scott Wilder
By , Editor
Updated

Your break-even miles are your weekly fixed costs divided by what each mile earns after variable costs. Run it with your numbers, test a short week, and see whether to push the rate or cut a cost first.

Your break-even miles are your weekly fixed costs divided by your margin per mile. On $1,400 of fixed costs and a $1.30 margin, that is about 1,077 miles. Below you will run it with your own numbers, test it against a short week, and know whether to push the rate or cut a cost first.

Break-even miles equal weekly fixed costs divided by margin per mile

The standard break-even rate is weekly fixed costs divided by weekly total miles, plus your variable cost per mile. Flip it around and you get the miles:

Break-even miles = weekly fixed costs / (rate per mile minus variable cost per mile)

The bottom of that fraction is your margin per mile. If it is zero or negative, no number of miles saves the week. Skip that load.

Example: say your weekly fixed costs are $1,400, your variable cost is $0.95 a mile, the rate you are paid is $2.25 a mile on total miles, and a normal week for you is 2,500 miles. Swap in your own figures.

  1. Margin per mile: $2.25 minus $0.95 = $1.30
  2. Break-even miles: $1,400 / $1.30 = about 1,077 miles
  3. Profit before tax at 2,500 miles: (2,500 minus 1,077) x $1.30 = about $1,850

Break-even is where profit starts. It is not the target.

Leave out empty miles and your rate floor lies

Use total miles, loaded plus empty, when you work out your floor. Fixed weekly costs and per-mile variable costs stay separate, and the rate floor uses total miles. Loaded miles alone make the floor look lower than it is, and loads that lose money start to look fine. If deadhead is eating your week, the deadhead guide shows how to price it in.

Fill in two inputs before you trust the answer

Fixed costs, per week. Tick off each one:

  • Truck payment
  • Insurance
  • Permits and fees
  • Anything else that does not change with miles

Divide monthly or yearly bills down to a week. A month has about four weeks, so mixing monthly and weekly figures throws the answer off by about four times.

Variable cost, per mile. Fuel, maintenance, tires, tolls, and anything else that grows with each mile.

Then check your all-in cost per mile against a published number. The industry-average cost to run a truck was $2.336 a mile in 2025, up 3.4 percent from 2024. That average includes driver pay and fleets of every size, so it is not your cost. But if yours comes out far below it, a line is probably missing.

Costs rose in every major line in 2025, with the biggest gains in tolls, repair and maintenance, driver benefits and tires. Check those lines first.

Break-even should sit under 70 percent of a normal week

Plan around a normal week, not your best one. Use your own average from the last 8 to 12 weeks. Hours of Service caps what you can run, so never plan a number you cannot legally drive.

Work out your cushion:

Cushion = normal weekly miles minus break-even miles

In the example: 2,500 minus 1,077 = 1,423 miles, or about 57 percent of the week. Break-even is about 43 percent of a normal week, and a short week of 1,500 miles still clears it by 423 miles.

This is a rule of thumb. Adjust it after a few weeks of your own numbers:

Break-even miles as a share of your normal weekWhat to do
Under 70%Room to be picky. Take loads for margin per mile, not volume.
70% to 90%Workable but thin. Run the $0.20 stress test below on every load.
90% or moreNo cushion. Raise the rate you accept or cut a fixed cost before you add loads.

Why 90 percent: on a 2,500 mile week, 90 percent is 2,250 miles. A week that runs just 10 percent short lands right on zero profit.

A $0.20 rate drop adds about 196 break-even miles

This is the stress test. Drop the rate by $0.20 a mile and redo the math.

  • New margin: $2.05 minus $0.95 = $1.10
  • New break-even: $1,400 / $1.10 = about 1,273 miles

That is about 196 more miles before the week turns black. Pass the test if the new break-even stays under the miles of your worst recent week. Fail it and the load needs a better rate.

The effect grows as the margin shrinks. With a $1.00 margin, break-even is 1,400 miles. Drop the rate by $0.20 and the margin is $0.80, so break-even jumps to 1,750 miles, a gain of 350.

You can also ask what rate you need at a mileage you can hit. At 2,500 miles, the break-even rate is $1,400 / 2,500 + $0.95 = $1.51 a mile. At 1,500 miles it is about $1.88 a mile. Fewer miles means a higher rate to land in the same place.

Raise the rate first, cut a fixed cost second

When the cushion is thin, two levers change break-even. Compare them in the example:

ChangeNew break-evenProfit at 2,500 miles
Start1,077 milesabout $1,850
Rate up $0.10 a mile1,000 milesabout $2,100
Fixed costs down $100 a week1,000 milesabout $1,950

Both cut about 77 miles. The rate change keeps paying on every mile past break-even, so it adds $250 a week at 2,500 miles. The fixed cost cut adds $100. Push for the rate first. Cut a fixed cost when the rate will not move or when your week is short on miles.

Four mistakes make a thin week look safe

  • Planning around a best week. A 3,000 mile week sets a target your average week cannot hit.
  • Leaving a fixed cost out. Break-even miles come out too low and the week ends short.
  • Skipping the shorter week. Fixed costs do not shrink when miles do, so rerun the math at 1,500 miles.
  • Copying someone else's miles. A forum number or a carrier ad shows miles, not the margin on each one. Your costs set your answer.

Your next 10 minutes: get your own break-even miles

Write down your weekly fixed costs and your variable cost per mile. Pick the rate you are offered on your usual lanes. Run the three lines. Then drop the rate by $0.20 and run them again. If the second answer scares you, you know where to work first.

Run the same math before the next load

The math is simple, but it is easy to drop a line when a broker is waiting on you. HaulMath is built for exactly this kind of freight math, so you can check your cost per mile and break-even before you say yes. Try HaulMath.

Common questions

How many miles a week does an owner-operator need to run?
It depends on your costs. Divide your weekly fixed costs by your margin per mile (rate minus variable cost per mile) to get your break-even miles, then compare that to a normal week.
Do empty miles count in my break-even?
Yes. Use total miles, loaded plus empty, when you work out your rate floor. Loaded miles alone make the floor look lower than it really is.
What happens to my break-even if I run fewer miles?
It goes up. Fixed costs stay the same, so each mile has to carry more of them and the rate you need per mile rises.
Should I raise my rate or cut fixed costs first?
Raise the rate first when you can. In the example, a $0.10 rise adds about $250 a week at 2,500 miles, while a $100 fixed cost cut adds $100.
What if my rate per mile is lower than my variable cost per mile?
Then there is no break-even mileage. Every extra mile loses money, so skip the load or push for a higher rate.

Run your own numbers

Free calculators for owner-operators: load profit, cost per mile, IFTA, per diem, and more. Every answer shows the math.