Skip to content
Haul Math

Blog

How to Figure Out Your Cost Per Day Running a Truck

Scott Wilder
By , Editor
Updated

Your truck costs money every day it exists, moving or not. Here is how to turn your fixed costs into one daily number and use it on short, slow and layover loads.

Add up every cost that does not change with miles, then divide by the days in the month. That is your cost per day, and you owe it whether the truck runs 600 miles or sits in a yard. By the end of this post you will have that number and a way to use it on loads where the truck gets held up.

If you want the per-mile side first, it is in how to calculate your trucking cost per mile. This post covers the other half, the one that decides short loads, slow lanes and layovers.

You can also run the numbers in HaulMath when you are done reading.

Fixed cost per day is what the truck costs while it sits

A fixed cost is anything you pay whether the truck moves or not. Bobtail's cost per mile guide lists truck payment or lease, insurance premiums, permits and licenses, an ELD subscription, accounting or admin, and health insurance. Overdrive puts it plainly: it is a daily expense you face 365 days a year, whether you drive one mile or 600.

Variable costs are the ones that change with miles: fuel, maintenance and repairs, tires, tolls and DEF, as Rigbooks lists them. Keep the two piles apart. Fuel goes in the per-mile number. If you also put it in the daily number, you count it twice.

Three steps give you the number

  1. Pull last month's statements for each fixed line: truck payment, insurance, plates and permits, ELD and phone, accounting, health insurance.
  2. Add them up. One column, one total.
  3. Divide by the days in that month. Use calendar days, not working days. The cost runs on the days you park, too. Weekly works the same way: total divided by 7. Yearly: total divided by 365.

If you divide by working days only, your daily number looks smaller than it is, and every load looks a little better than it should.

Write the result at the top of your load sheet: Fixed per day: $____. Redo it when a premium, payment or plate fee changes.

Check your total against real monthly samples

Here are two outside examples to test your number against. Neither is a target.

Overdrive shows one operator's month: truck payment $4,980, insurance $690, license plates with IRP $154, and PrePass $25, for $5,849 a month. Divide by 30 and that is about $195 a day.

Rigbooks gives typical ranges by line:

Fixed costTypical monthly range
Truck payment$1,500 to $2,500
Insurance (liability, cargo, physical damage)$800 to $1,800
Permits and plates$200 to $400
Health insurance$400 to $1,200
Phone and ELD$50 to $150
Total$2,950 to $6,050

That range works out to roughly $98 to $202 a day. For a wider benchmark, ATBS reported that fixed costs averaged $269 a day for its owner-operator clients in 2023, not counting the owner's own pay. If your number is far outside these, check that you did not leave out a line or add a variable one.

Run two loads at the same rate per mile and watch the leftover change

Example: say your fixed cost is $150 a day ($4,500 a month divided by 30) and your variable cost is $0.75 a mile. Two loads both pay $2.50 a mile.

Load ALoad B
Loaded miles600300
Rate$1,500$750
Days the truck is held22 (one driving, one waiting on the reload)
Variable cost (miles x $0.75)$450$225
Fixed cost (days x $150)$300$300
Left over$750$225
Left over per day held$375$112.50

Same rate per mile. Very different outcomes. Overdrive makes the same point about looking at cost in relation to time, not just miles: two loads that pay the same per mile can leave you with very different money for the time invested.

For the formula behind the table: rate, minus variable cost per mile times all miles (loaded and empty), minus fixed cost per day times the days the trip holds the truck.

Count the deadhead miles. A playbook for new owner-operators shows how a load posted at $2.00 a mile ($1,400 for 700 loaded miles) becomes about $1.79 once you add 80 deadhead miles.

When to use the day and when to use the mile

  • Long load, truck moves every day: use cost per mile. It is the faster check, and the daily cost is mostly spread out already.
  • Short load, or the truck sits before or after it: use cost per day. The held days are where the money goes.
  • A lane you know is slow: price the waiting day at your fixed cost per day before you accept.

If you want a second example of the same idea, how to calculate profit per day on a trucking load goes through a full load, and is a short haul load worth it covers the short-haul side.

Price a layover from your own number, not a forum guess

When the truck is held, your fixed cost per day is the floor for what the delay costs you. Published layover figures vary. O Trucking says owner-operator layover pay commonly lands around $100 to $300 a day after about 24 hours of non-productive delay. That is a wide band, and your cost may sit above or below it. Use yours.

Sample wording for a broker (adjust the numbers):

"My truck costs me $[your number] a day whether it moves or not. The delay is day [N], so the rate has to cover it."

For hourly waits at a shipper or receiver, see how to calculate and bill detention pay.

Four mistakes that make your daily number wrong

MistakeWhat it costs you
Dividing by working days onlyThe daily number looks smaller than it is, so every load looks better.
Using last year's insurance figureThe number is too low until the next statement catches up.
Leaving out health insurance, ELD or phoneSmall lines add up to a real number across 30 days.
Putting fuel or tires in the daily numberThey get counted again in the per-mile number.

Do this in the next ten minutes

  1. Open last month's statements and write down each fixed line.
  2. Add them and divide by the days in the month.
  3. Write "Fixed per day: $___" at the top of your load sheet.
  4. Next time a broker offers a short or slow load, count the days it holds the truck and multiply.

Do the math in seconds when the broker is waiting

You can do all of this on paper, and the steps above work as they are. If you would rather have the arithmetic done while you are on the phone, try HaulMath. It is a calculation tool built for owner-operators and small fleets. It does the math you enter, so your results are only as good as the costs you put in, and it does not replace an accountant for tax or financial planning.

Common questions

How do I calculate my truck's cost per day?
Add all your fixed costs for a period (a week, a month or a year) and divide by the days in that period: 7, about 30, or 365. Fixed costs include truck payment, insurance, permits and plates, ELD, phone, accounting and health insurance.
Should I divide by 30 or by the days I work?
Divide by calendar days. The fixed costs run on the days the truck is parked too, so dividing by working days makes your daily number look smaller than it is.
Is fuel part of cost per day?
No. Fuel is a variable cost and belongs in your cost per mile. Putting it in both numbers counts it twice.
When should I use cost per day instead of cost per mile?
Use cost per day on short loads, slow lanes and loads where the truck sits before or after. Use cost per mile on long loads where the truck moves every day.
How much should I charge for a layover?
Start from your own fixed cost per day, since that is what the held day costs you. One 2026 guide puts owner-operator layover pay around $100 to $300 a day after about 24 hours of delay, but your number matters more than a range.

Run your own numbers

Free calculators for owner-operators: load profit, cost per mile, IFTA, per diem, and more. Every answer shows the math.